Contemporary-control-systems BASremote Installation Guide Manual de usuario descargar pdf (Pagina 9)

TD040300-0II

CABLING CONSIDERATIONS

When attaching cables to the BASR, Table 1 should be considered.

Function

Signalling &

Data Rate

Minimum Required

Cable

Maximum

Segment Distance

Ethernet

10BASE-T

10 Mbps

Category 3 UTP

100 m (328 ft)

Ethernet

100BASE-TX

100 Mbps

Category 5 UTP

100 m (328 ft)

I/O

Unspecified

18 AWG

Unspecified

Expansion

Unspecified

Belden

9841 or equivalent

100 m (328 ft)

Modbus

2.4–115.2 kbps

Belden

9841, 3106A, 9842

100 m (328 ft)

Table 1 — Cabling Considerations

NOTE: If using shielded cable, connect to chassis at only one point. Wire

size may be dictated by electrical codes for the area where the equipment is

being installed. Consult local regulations.

Observe in Table 1 that 10BASE-T segments can successfully use Category 3,

4 or 5 cable — however, 100BASE-TX segments must use Category 5 cable.

Category 5e cable is highly recommended as the minimum for new installations.

The Ethernet port of the BASR employs Auto-MDIX technology so that either

straight-through or crossover cables can be used to connect to the network.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentarios a estos manuales

Sin comentarios

Contemporary-control-systems BASremote Installation Guide Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Contemporary-control-systems BASremote Installation Guide