
TD071200-0IK
6
2.7 Connectors
3-pin (MS/TP) Pin Assignments
(Also explained on product label)
RJ-45 (MDI Ethernet) Pin Assignments
1 TD + 3 RD +
2 TD – 6 RD –
(All other pins are unused.)
USB Mini B Connector (Aux)
This connector is only used for
firmware upgrades.
EIA-485 Bias and Termination Jumpers
U Install jumper to apply pull-up bias.
T Install jumper to terminate bus.
D Install jumper to apply pull-down bias.
(All jumpers are installed by default.)
2.8 Mechanical
Figure 5 — Product Dimensions
Figure 2 — RJ-45 Connector
Figure 4 — Internal Jumpers
Figure 1 — 3-pin Connector
Comentarios a estos manuales