Contemporary-control-systems Compact Managed Switches Software Manual for Conso Manual de usuario descargar pdf (Pagina 28)

TD020850-0MG

4.3.7.1 Configure Port QoS

When QoS is enabled, Flow Control for each port can be enabled or disabled. For

QoS to be most effective, it is recommended that each port have its flow control

disabled (the default setting). When a port is operating in half-duplex mode, flow control

is accomplished with backpressure. In full-duplex mode, flow control is accomplished

through the PAUSE protocol. These methods and protocols can affect the ability of a

port to deliver messages and can cause other messages to be delayed.

In the example of Figure 20, Port 2 has been configured for High priority while all other

ports are set to Normal. But Port 1 (set to Normal priority) is the only port on which

Flow Control will function because only it has had Flow Control Enabled.

Figure 20 — Configure Port QoS

NOTE: The sample screen above is the first of two displayed for a 16-port switch — or the first of

three displayed for a 24-port switch. The succeeding screens are accessed by choosing

the Continued option just above the dashed line. This option is not displayed in the

Configure Port QoS screen of an 8-port switch.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Sin comentarios

Contemporary-control-systems Compact Managed Switches Software Manual for Conso Manual de usuario Pagina 28